Filter
Top Products
7
Tool Rest
Position the tool rest as close to the workpiece as
possible. It should be slightly above the center line
of the workpiece.
Loosen the tool rest with the attached wrench (D,
fig. 4) and slide tool rest to desired position. Re-
tighten with wrench when finished with adjustment.
Adjust the height of the tool rest by loosening the
lever (E, Fig. 4). Tighten the lever when finished
adjusting. NOTE: The lever is spring loaded; simply
pull up on it, rotate it on the pin, and release.
Switch Safety Feature
When the switch is in “off” position, a part of the
switch can be pulled out (Fig. 5) to prevent
accidental starting of the lathe. The piece must be
re-inserted before operating the lathe.
Belt Tension
1. To adjust tension of the drive belt, open the
cover by turning the knob (A, Fig. 6) clockwise.
2. Loosen the screw (C, Fig. 6) using a hex
wrench.
3. Slide the bearing (B, Fig. 6) left to increase
tension, right to decrease tension.
Belt Replacement
1. To replace the drive belt, open the cover by
turning the knob (A, Fig. 6) clockwise.
2. Loosen the screw (C, Fig. 6) using a hex wrench
and slide the bearing (B, Fig. 6) to the right.
3. Remove the old belt and install new one around
the pulleys.
4. Re-tension the belt and close the cover.