Filter
Top Products
Setting the fence for
exact cut widths is
easy thanks to a
magnifying cursor
that is built into the
T-square base. The
cursor is adjustable
side-to-side to
insure maximum
precision after the
fence is installed and
aligned.
The fence system is
supported front and
back on heavy steel rails and guide tube. An adjustable height pad at the rear of the
fence allows it to glide across the table smoothly. The pure strength of this mounting
system creates a stable, permanent base that insures accuracy and easy of use for
decades.
The new ProShop T-square style fence (left) is rigid and very accurate. A
large scale and adjustable, magnified cursor (right) make setting precise
cuts simple.
The 20” by 27” cast iron table surface is precision ground to insure it is perfectly flat.
The useable surface expands to 44” by 27” with the extension wings. The JET
ProShop 10" Table
Saw is available with
heavy-duty steel or
precision-ground
cast iron extension
wings. A pair of T-
style miter slots are
precision milled into
the table surface.
The ¾”-wide by
3/8”-deep miter
slots accept all
common table saw
accessories.
The ProShop Saw comes with a quality, angle-adjustable miter gauge (left)
and features an adjustable-width guide bar (right) to insure a perfect fit to
the slot for maximum accuracy.
A fully adjustable miter gauge comes with the JET ProShop 10" Table Saw. The guide
bar features a removable T-slot follower and width adjusters to eliminate side play
for super-stable cuts. The head can be set to any angle from 0 to 60-degrees left or
right with adjustable stops at 0 and 45-degrees, also on both sides of zero.