Filter
Top Products
28
JWL-1442VS Safety Guard (optional accessory)
Safety Guard
1. Mount the guard bracket (A) to the headstock with two 3/8” flat washers, two 3/8” lock washers and
two 3/8”-16 x 1-1/2” socket head cap screws (B).
2. Attach the guard (C) to the guard bracket by inserting the rod and lifting up on the plunger (D).
3. There are two detents that will hold the guard in place. One is for turning and the other is for when
you need the guard up and out of the way. Simply lift up on the plunger and rotate the guard until the
plunger slips into the detent.
4. Tighten the bushings (E) against the bracket with two setscrews (F).