Jet Tools JWL-1642EVS-2 Lathe User Manual


 
11
Guard
1. Attach guard to the bracket by inserting the
rod and lifting up on the plunger (A, Fig. 5).
2. There are two detents that will hold the
guard in place. One is for turning and the
other is for when you need the guard up and
out of the way.
3. Tighten the bushings (B, Fig. 5) against the
bracket with two setscrews (C, Fig. 5).
Controls and Features
1. Headstock Lock Handle: (D, Fig. 6) Locks
head in position. Unlock handle to position
the head along lathe bed. Tighten handle
when properly positioned.
2. Headstock Spindle Lock: (E, Fig. 6) Push
pin in to keep the spindle from turning.
CAUTION! Never press the headstock
spindle lock while the spindle is turning!
3. Headstock On/Off Button: (F, Fig.6) Pull
the button out to turn “ON” the lathe. Push
the button in to turn the lathe “OFF”.
4. Headstock RPM Knob: (G, Fig. 6) Turn
knob to desired RPM. There are two speed
ranges offering “speed” (0-3200) and
“torque” (0-1,200).
5. Headstock For/Rev Switch: (H, Fig. 6) Use
the toggle switch to change the direction the
spindle turns. Only change direction when
the spindle has stopped.
6. Headstock RPM Readout: (I, Fig. 6)
Displays the spindles RPM, see Figure 7.
7. Headstock Spur Center: (J, Fig. 8) Used
for turning between centers. Spindle taper is
MT-2. Remove spur center by inserting drift
rod through the opposite end of the spindle
and knocking spur center out.