Filter
Top Products
7
Installation
Tools required
7/16" and 1/2" wrenches
Cross point screwdriver
3/16" hex wrench
Adjustable square
Hammer (or rubber mallet)
Straight edge
The following instructions are for installing the
XACTA Fence II and Rail System on JET Models
JTAS-10 and JTAS-12 series table saws. The
Rails should bolt up to the JET saw without any
drilling.
Front Rail Installation
Referring to Figures 1 and 2:
1. Identify the front rail (E), which is
2-1/2" x 2-1/2" with notches on one side and
countersunk mounting holes on the other side.
2. Lightly secure the front rail (E) to the table (G)
and extension wings (F) with four 1/4 x 1-1/2
flat head screws (A) four 1/4” flat washers (B),
four 1/4” lock washers (C) and four 1/4” hex
nuts (D). Tighten just enough to hold the rail
next to the table but keep loose enough to
allow height adjustment.
The front rail must be 9/16" down from the table
top in order to clear the miter gauge slot. This
measurement is critical.
3. Place an adjustable square on the table as
shown in Figure 3.
4. Check the height of the Front Rail at several
locations along the surface of the saw table.
The front rail must be parallel with the table
top.
5. When the Front Rail has been correctly
positioned, tighten all mounting screws
securely with a #3 cross point screwdriver and
7/16" wrench.
Figure 1
Figure 2
Figure 3