Filter
Top Products
8 3 1/4-Inch Belt Sander Operator's Manual
POLARIZED PLUGS
To reduce the risk of electric shock, this equipment has a polarized plug (one blade is
wider than the other).
This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug any way.
CAUTION
ALWAYS KEEP THE MOTOR AIR VENT FULLY OPENED
A constantly open motor air vent is necessary to allow air to come in and out for cooling
the motor. Do not allow it to become clogged up, even if dust is blown through it.
OPERATE POWER TOOLS AT THE RATED VOLTAGE
Operate power tools at voltages specified on the nameplates.
STOP OPERATION IMMEDIATELY IF ANY ABNORMALITY IS DETECTED
Should a power tool be detected as out of order or should other abnormalities be
observed during operation, stop using the tool immediately.
NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF.
Don't leave tool until it comes to a complete stop.
CAREFULLY HANDLE POWER TOOLS
Should a power tool be dropped or struck against hard materials inadvertently, it may be
deformed, cracked, or damaged.
DO NOT WIPE PLASTIC PARTS WITH SOLVENT
Solvents such as gasoline, thinner, benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents. Wipe plastic
parts with a soft cloth lightly dampened with soapy water.
WHEN REPLACING A COMPONENT PART, ADOPT THE SAME TYPE
When replacing a component part with a new one, adopt the same type of new part.
Also, never attempt to repair a power tool yourself.