Kalorik PPG-36584 Sander User Manual


 
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
4 PPG 36584 - 120501
Assembly page 4/26
Fax +1 305 430 9692
BEFORE USE
This appliance runs on a battery pack of 2 x AA type
rechargeable batteries. The batteries are pre-installed in the
motor housing.
If the original batteries need to be replaced later, open the
batteries housing by sliding the 2 white tabs at the bottom of the
motor housing towards the centre. Slide the motor block out to
access the battery cavities.
Do not replace the rechargeable batteries with non-
rechargeable ones, as these could catch fire.
If the rechargeable batteries need replacing, only do with a
rechargeable battery pack of the same type and specifications
(Ni-Mh type, AA size, 650mA)
To fill in pepper or salt:
Simply lift off the lid of each container and fill
them with coarse sea salt, peppercorns of
other spices suitable to be ground (fig. 4).
Put the lid back in place to keep the content
fresh and dry, until ready to grind.
Do not fill the containers completely, for best
performance.
CHARGING
Remove the grinder and components from the packaging.
Plug the charger cord (12) into the charging base (10), and plug
charger (11) into the socket
With the socket for the adapter (10, 12)) at the right back side,
and the grind switch (2) on the motor block (1) positioned
towards the front, place the motor block (1) on the center of the
base (7) and turn the motor block clockwise, until it locks in place
and a red pilot light (10) on the base lights up.
Charging will take approx. 3-4 hours for the first time.
For longer battery life, leave the grinder to charge for up to 8
hours continuously. Then unplug the adapter from the socket and
discharge the batteries to the maximum before recharging.