Filter
Top Products
9
OPERATING THE ON / OFF SWITCH
Press the “ON/OFF” switch to turn the worklight “ON” and “OFF”.
ADJUSTING THE WORKLIGHT BEAM
Hold the handle of the Worklight securely in
one hand. With the other hand, swivel the head
of the Worklight counter-clockwise until it is at
the angle you desire. Swivel the head of the
Worklight clockwise to return it to its original
position.
REPLACING THE LIGHT BULB
This Worklight uses a Krypton 19.2V, 0.6 A light bulb. Use of any other kind
of light bulb may cause damage or injury.
Parts of this worklight heat up almost immediately when in use. To avoid
burns, use caution when handling light bulb and metal reflector. Never change
a hot light bulb. Bulb must be cool to the touch before attempting to remove or
replace it.
For your convenience, a spare light bulb is included
inside the unit. Unscrew the rim and carefully remove it from the light
assembly.
10
CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Plug the charger into the nearest
120 volt electrical outlet. The step of
the battery has positive and terminal
markings on it. Align the markings
on the identical markings on the top
of the charger base. Insert the
battery pack into base. Pack will not
insert properly if reversed.
2. Make sure the trigger on the
Cordless Worklight is in the “OFF”
position and remove the battery pack
from the Cordless Worklight.
3. If, when first inserting the battery pack, the red “ON” button does not light up,
press the “SET” button on the charger. When the battery is charging, the red
light is “ON”.
4. After approximately one hour of charging, the red indicator light should go
“OFF” and the green light should come “ON”. The green light indicates that the
battery is fully charged.
5. When fully charged, reattach battery pack onto Cordless Worklight, making cer-
tain latches fasten securely. Cordless Worklight will not operate properly if the
battery pack is not saeted properly.
OPERATING THE WORKLIGHT
Parts of this Worklight heat up almost immediately when
in use. To avoid burns, use caution when handling light bulb and metal reflector.
Never change a hot light bulb. Bulb must be cool to the touch before attempting
to remove or replace it.
UP
BATTERY PACK
BATTERY
CHARGER