Filter
Top Products
CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Make sure the trigger
on the Cordless Circular
Saw is in the “OFF”
position and remove the
battery pack from the
Cordless Circular Saw.
2. Plug 120V AC Adapter
into household outlet
and into side of battery
charger. Insert battery
pack into battery charger.
When the battery is
placed in the charger, the
red LED indicator light will remain on.
3. When fully charged, reattach battery pack onto Cordless Circular Saw,
making certain latches fasten securely. Cordless Circular Saw will not
operate properly if the battery pack is not seated properly.
ASSEMBLY
Always remove battery pack before installing or removing blade.
When removing the blade from the tool, avoid contact with skin and use
proper protective gloves when grasping the blade or accessory. Accessories
may be hot after prolonged use.
14
REMOVING / ATTACHING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release
buttons on either
side of the Cordless
Circular Saw to release
the battery pack.
2. Pull battery pack free of
Cordless Circular Saw.
ATTACH BATTERY PACK:
1. Align the raised portion
of the battery pack with
the groove in the
battery compartment of the Cordless Circular Saw.
2. Press the battery pack into place. Make sure the latches are securely fastened.
Do not use the Cordless Circular Saw if the battery pack is not seated properly.
CHARGER
Before using battery charger, please read carefully all
instructions and cautionary markings on battery charger, battery pack and
product using battery.
The charger will not automatically turn “OFF” when the
battery pack is fully charged. The charging indicator light will remain “ON”
until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as
listed in this manual. Do not substitute any other charger. Use only Alltrade
approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet
or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
non-flammable surface away from flammable materials with at least four inches of
clearance to allow proper air circulation around the charger and battery pack.
When the battery pack requires recharging, a 3 hour charge allows the tool to
operate at full power. A charging indicator light on the charger will illuminate to
show that charging is taking place.
13
RELEASE
BUTTON
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
BATTERY
CHARGER