Filter
Top Products
GENERAL CUTTING
Always hold the saw in front of you and away from your body. Keep your
hands and feet well away from the work piece.
Never feed the blade into the work piece until the blade is at full speed. If
the blade is not at full speed, the saw may kick back causing serious
personal injury.
Do not force the saw. Excessive force may result in a
broken blade. Use only enough pressure to keep the saw moving through the
work piece.
• Put on eye
protection.
• Clear the saw of any
foreign material.
• Make sure the work piece is held
securely in place. Hold smaller pieces
in a vise or attach to the workbench
with clamps.
• Mark out the line to be cut so it is easily visible.
• Pull the trigger to start the saw.
• Set the shoe against the work piece.
• When the blade reaches full speed, slowly feed the blade into the work piece.
PLUNGE CUTTING
Never feed the blade into the work piece until the blade
is at full speed. If the blade is not at full speed, the saw may kick back
causing serious personal injury.
Do not force the saw. Excessive force may result in a
broken blade. Use only enough pressure to keep the saw moving through the
work piece.
10
VARIABLE SPEED TRIGGER SWITCH AND LOCK-ON BUTTON
Never tape the trigger switch down to provide continuous
high speed. The tool may fail under such conditions causing fire or personal
injury.
THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
• The speed of the Reciprocating
Saw depends on the amount of
pressure applied on the trigger.
The further the trigger is pressed,
the faster the tool will go.
• To maintain a certain speed, pull the “On/Off” trigger to turn the Reciprocating Saw
“ON” and engage the lock-on button. To turn the Reciprocating Saw “OFF”,
release the trigger switch. The lock-on button will automatically reset.
ATTACHING / REMOVING BLADE
TO ATTACH BLADE:
• Turn the blade
clamp to the
right with fingers.
• Insert blade, then release
the blade clamp to make
sure it is securely fastened.
• Make sure that the teeth are
facing downward.
TO REMOVE BLADE:
• Turn the blade clamp to the right with fingers.
• Pull off blade.
9
BLADE CLAMP
TRIGGER
LOCK-ON BUTTON