VARIABLE SPEED TRIGGER SWITCH
THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
• The speed of the Cordless Impact
Wrench depends on the amount of
pressure you put on the trigger.
• The more pressure you apply, the
faster the Cordless Impact Wrench
will go.
• Release the pressure and the
Cordless Impact Wrench will slow
down.
FORWARD/ REVERSE AND TRIGGER LOCK LEVER
Be sure the trigger is released when changing the position of the lever.
Always store the tool in the “LOCKED/OFF” position.
Always check the direction of the Cordless Impact Wrench's rotation before use.
TO SELECT THE DIRECTIONS
OF ROTATION:
• To select forward Cordless Impact
Wrench rotation, press the trigger
lock from left to right flat against the
Cordless Impact Wrench body.
• To select reverse, press the trigger
lock lever in the opposite direction.
• The center position locks the tool.
14
ASSEMBLY
Be aware that this tool is always in an operating condition
because it does not have to be plugged into an electrical outlet. Always turn
the switch “OFF” and remove the battery pack before changing bits.
INSTALLING/ REMOVING SOCKET ON THE ANVIL
When removing the socket or bit from the tool, avoid
contact with skin and use proper protective gloves when grasping the socket,
bit or accessory. Accessories may be hot after prolonged use.
When installing a socket, align the
holes in the side of the socket with the
dent pin. Press the socket on until the
dent pin engages in the hole. To remove a
socket, depress the dent pin through the
hole using a small pointed object and pull
the socket off.
OPERATING THE IMPACT WRENCH
Never tape the trigger switch down to provide continuous
high speed. The tool may fail under such conditions causing fire or
personal injury.
13
TRIGGER
SWITCH
TRIGGER
LOCK