Filter
Top Products
OPERATING THE RECIPROCATING SAW
Be aware that this tool is always in an operating condition
because it does not have to be plugged into an electrical outlet. Always turn
the switch “OFF” and remove the battery pack before changing blades.
VARIABLE SPEED TRIGGER SWITCH
Never tape the trigger switch down to provide continuous
high speed. The tool may fail under such conditions causing fire or personal
injury.
The lock-off button helps prevent accidental starting.
This button can be pressed from either side.
THIS TOOL IS CONTROLLED BY A TRIGGER SWITCH:
• The speed of the Cordless Reciprocating Saw depends on the amount of
pressure applied on the trigger. The further the trigger is pressed, the faster
the tool will go.
• Press the lock-off button, then pull the “ON/OFF” trigger to turn the Cordless
Reciprocating Saw “ON”. To turn the Cordless Reciprocating Saw “OFF”,
release the trigger switch.
14
ASSEMBLY
Failure to remove the battery pack from the saw before
removing the blade could result in accidental starting and serious personal
injury.
ATTACHING / REMOVING BLADE
• Remove the battery pack.
TO ATTACH BLADE:
• Rotate the clamp knob clockwise and hold to retract the clamping jaws inside
the clamp.
• Insert the shank of the blade into the clamp until the hole in the shank engages
the dent ball in the clamp.
• Release the clamp knob to tighten and secure the blade in place.
• Replace the battery pack.
TO REMOVE BLADE:
• Rotate the clamp knob clockwise and hold to retract the clamping jaws inside
the clamp.
• Pull the blade off the clamp.
• Replace the battery pack.
13
TRIGGER
LOCK-ON
BUTTON
BLADE CLAMP