Filter
Top Products
9
OPERATING THE WORKLIGHT
Parts of this Worklight heat up almost immediately when
in use. To avoid burns, use caution when handling light bulb and metal reflector.
Never change a hot light bulb. Bulb must be cool to the touch before attempting
to remove or replace it.
OPERATING THE ON / OFF SWITCH
Press the “ON/OFF” switch to turn the worklight “ON” and “OFF”.
ADJUSTING THE WORKLIGHT BEAM
Hold the handle of the Worklight securely in
one hand. With the other hand, swivel the head
of the Worklight counter-clockwise until it is at
the angle you desire. Swivel the head of the
Worklight clockwise to return it to its original
position.
REPLACING THE LIGHT BULB
This Worklight uses a Krypton 18V, 0.3A light bulb. Use of any other kind of
light bulb may cause damage or injury.
Parts of this worklight heat up almost immediately when in use. To avoid
burns, use caution when handling light bulb and metal reflector. Never change
a hot light bulb. Bulb must be cool to the touch before attempting to remove or
replace it.
10
CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Plug the charger into
the nearest 120 volt
electrical outlet.
2. Make sure the trigger
on the Cordless Worklight
is in the “OFF” position
and remove the battery
pack from the Worklight.
3. Insert the battery pack into
the charger. Be sure that the
battery pack is fully seated
in the charger.
Do not force.
4. The red indicator light should come “ON” indicating that the battery pack is in
a “Fast Charge” mode. If the green indicator light comes “ON”, then the battery
is already fully charged.
5. After approximately one hour of charging, the red indicator light should go
“OFF” and the green light should come “ON” indicating that the battery is fully
charged and the charger is now in a “Trickle Charge” mode.
6. The battery can be left in a “Trickle Charge” mode until ready to use.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your Worklight continuously, the batteries in your battery pack
will become hot. You should let a hot battery pack cool down for approximately
30 minutes before attempting to recharge. When the battery pack becomes
discharged and is hot, the red light on the charger will flash. When the battery
pack cools down, the red light will glow continuously to indicate fast charging
mode, 1-hour charge time.
This will occur when continuous use of your Worklight
causes the battery pack to become hot. It does not occur under normal
circumstances.
BATTERY PACK
LED
LIGHT
BATTERY
CHARGER
UP
DOWN