Filter
Top Products
Outside Faucet
(Hard Water)
Soft, Cold Water
Soft, Hat Water
Remote Location
Installation
Outside Faucet
(Hard Water)
Line
GREEN
Tubing to Reverse
Osmosis System
Sediment Filter
Soft, Cold
c_ Sump
I--I Air_ap
W2"
Stand pipe Airgap
Water Heater
Laundry Tub
Floor
Drain
Figure 10
Main
Shutoff
Valve
BLUE Tubing
to Reverse
Osmosis Air
Gap Faucet
Reverse
Osmosis
YELLOWTubing
toTankStorage
I
Storage
Tank
Water Meter
Figure 9
INSTALL A REMOTE DRAIN POINT AND AIR GAP
(Remote Location)
You can also run the drain tubing to an existing drain in
the house. A floor drain, laundry tub, standpipe, sump,
etc. are suitable drain points. See Figure 10. This type of
drain is the preferred over the p- trap drain adapter.
Check your local codes. Longer lengths of tubing (see
parts list in back of manual) may be needed.
Always be sure to provide an air gap between the end of
the hose and the drain point. This will prevent water from
backing up into the system. Airgaps are required code in
most areas.
To install a remote drain point, complete the following
steps:
1. Locate the 1/4" red tubing on the Reverse Osmosis fil-
ter assembly. See Figure 9.
2. Determine if this length is long enough to reach the
drain point.
3. If not, disconnect the 1/4" red tubing and replace with
an adequate length of tubing to reach the drain point.
Refer to Step 6 later in the manual on how to discon-
nect and connect tubing.
NOTE: A flow control insert is located in the red tube.
Refer to Key No. 14 on Page 26. This insert must be
saved and placed in the new length of tubing.
4. Run the tubing to the drain point and secure at the end
with a bracket (purchased locally). See Figure 10.
Provide a 1-1/2" air gap between the end of the tube
and the drain. See Figure 10.
Questions? Call The I<enmore Water Line 1-800-426-9345 or visit KenmoreWater.com
10