Filter
Top Products
A
vlvl,,1:i _II_[,e
ALL ELECTRICAL WIRING SHOULD BE DONE
BY A QUALIFIED ELECTRICIAN
General Information
Adequate wiring and motor protection
should be provided for all stationary
compressors. Wiring used for other
machinery should not be used. A
qualified electrician familiar with local
electrical codes in your area should be
used.
To reduce the risk of electrical hazards, fire
hazards or damage to the compressor, use
proper circuit protection. Your compressor
is wired at the factory for operation using
the voltage shown. Connect the compressor
to a power source with the correct breaker
size.
Electrical connections must be propedy
grounded. Ground connections should be
connected at the grounding screw.
,4,
il;lll I [I] _
Overheating, short circuiting and fire damage
will result from inadequate wiring.
Incoming power should
be connected to the
posts marked (line)
Do Not Make
Connections On
Prewired Posts (Motor)!
Grounding Screw
K7060V K7580V2
K7060HFV
Voltage 230V / 1 ph 230V / 1 ph
FLA 16 23
Breaker Size 30 amp 40 amp
The motor is equipped with a manual,
resetable ovedoad device to protect it from
overheating. In the event the compressor will
not run and power is properly connected and
on, press the motor ovedoad reset button
located on the non drive end of the motor.
Prior to actually running the compressor,
check the following items:
Crankcase oil - Make sure the sight glass
shows ½ full or slightly above.
Make sure all rags, tools, oil, etc. are away
from the unit.
Open the air system to free itof any pressure.
Switch the compressor on for a few
revolutions to make sure the rotation is
correct. Correct rotation is clockwise
when facing the sight glass on the pump.
Operate the compressor for a few minutes
unloaded (air system open) then allow the
compressor to pump up. Make sure the
electdcal pressure switch propedy switches
off the compressor according to the setting
desired. (135 psi for K7060V/K7060HFV
and 175 psi for K7580V2)
Make sure the pressure in the tank does
not exceed its rating. Single stage comp-
ressors should operate at a maximum of
135 psi and two stage compressors should
operate at a maximum of 175 psi. If the
pressure gauge indicates a pressure that
is higher than these maximum pressures,
shut off compressor immediately and call
1-866-242-4298.
Page 6