Filter
Top Products
86216Ć2ĆBA (Ć)
6 Kohler Co., Kohler, WI
STACKING MULTIPLE UNITS
14.
The following
cautions apply to stacking on
freestanding bases.
The higher units are
stacked, the more unstable
the assembly becomes.
If units are utilized in a
manner where most of the
weight is placed in the
upper part of the cabinet
the units may become
unstable.
If units are stacked above
60" high the assembly
becomes very unstable.
When stacking units on
wallĆmount bases, make sure to
secure each cabinet to the wall.
Only the case drawers
may be stacked with the storage
cases or other case drawers. The
case drawers have two equal
sized drawer compartments.
Stack the two units on top of one
another. Make sure units are
square to each other.
Measure in from the front edge
of the top unit approximately 1"
and approximately 1" from
either side. Mark each location.
Drill a hole at each mark
through the top of the bottom
unit and approximately 1/4" into
the bottom of the top unit. Do
not drill completely through the
bottom of the top unit. Make
sure to use a drill of adequate
diameter to accommodate
fasteners (not provided).
Secure with fasteners (not
provided).
1"
1"
Drill holes 1/4" into
the top unit
Top Unit
Bottom Unit