Filter
Top Products
86217Ć2ĆAA (C)
2 Kohler Co., Kohler, WI
CASE DRAWER UNITS:
Determine the desired location
of the case drawer unit.
Measure down 3Ć1/8" from
where the top edge of the case
drawer will be located and 2Ć1/2"
in from where the left edge will
be located. Make a mark at this
point.
While holding the cleat with the
largest side facing away from the
wall, align the left hole in the
cleat with the mark on the wall.
Make sure cleat is level and
predrill holes into the wall to
align with the holes in the cleat.
Use a drill of adequate diameter
to accommodate fasteners (not
provided).
Secure cleat to wall with
fasteners (not provided).
Case Drawer Unit
Cleat
2Ć1/2"
3Ć1/8"
2ĆDRAWER VERTICAL UNITS:
Determine the desired location
of the drawer unit.
Measure down 3Ć1/8" from
where the top edge of the
storage unit will be located and
2Ć1/2" in from where the left
edge will be located. Make a
mark at this point.
While holding the cleat with the
largest side facing away from the
wall, align the left hole in the
cleat with the mark on the wall.
Make sure cleat is level and
predrill holes into the wall to
align with the holes in the cleat.
Use a drill of adequate diameter
to accommodate fasteners (not
provided).
Secure cleat to wall with
fasteners (not provided).
2ĆDrawer Vertical
Unit
Cleat
2Ć1/2"
3Ć1/8"