Filter
Top Products
10 GB/IE
General safety... / Safety advice relating to cordless drill drivers / Before first use
Q
Attention - Service lines!
WARNING!
Take steps to ensure that
you do not hit upon any service lines
(electricity, gas, water) when working
with electrical appliances. Check, if need be
with a service line detector, before you start to cut
or bore into a surface.
Q
Original ancillaries /
accessories
J Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and
accessories other than those recommended in
the operating instructions could lead to an
increased risk of personal injury for you.
Safety advice relating
to cordless drill drivers
J Securely support the workpiece. A
workpiece held in a clamp or vice is kept more
securely in place than one held by your hand.
WARNING!
POISONOUS DUSTS!
J Harmful / noxious dusts generated from your
work represent a risk to the health of the person
operating the device and to anyone near the
work area.
J
Wear safety glasses and a dust
mask!
J Do not drill any material containing
asbestos. Asbestos is a known carcinogen.
J Hold the electrical power tool firmly.
High reaction torques may occur momentarily
during tightening or loosening of screws.
J If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback. The inserted tool may jam if
the electrical power tool is overloaded or is
held at an angle to the workpiece.
WARNING!
The inserted tool may
strike concealed electricity cables,
therefore when working you must
hold the electrical power tool by the
insulated handle areas only. Contact
with a live wire means that the metal parts of
the electrical power tools may become live and
this can result in an electric shock.
J Before you carry out any tasks on the
device, transport or store it, make
sure that the direction of rotation
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.
Q
Before first use
Q
Removing / charging / inserting
rechargeable battery pack
WARNING!
Always disconnect the mains
adapter
10
from the mains supply before you
remove or insert the battery pack from/into the
charging station
12
.
Note: The battery is supplied partially charged.
Charge the battery in the charging station for at
least three hours before first use. By doing this the
battery will operate at its highest capacity. You can
charge the Li-Ion battery at any time without risk of
shortening battery life. Interrupting the charging
process does not damage the battery.
1. To remove the battery pack
6
press the bat-
tery unlocking button
7
and pull the battery
pack
6
forward off the device.
2. Push the battery pack
6
from the front into the
charging station
12
.
3. Insert the mains adapter
10
into the mains
socket. The mains adapter LED
11
illuminates.
4. Connect the mains adapter
10
to the charging
station
12
. The charging indicator LED
13
on
the charging station
12
illuminates red.
5. The green charge indicator LED
13
shows that
the charging process is complete and the
battery pack
6
is ready for use.
6. To remove the battery pack
6
press the
battery unlocking button
7
and pull the