Filter
Top Products
7 GB/IE/CY
Q
Technical information
Nom. power input: 260 W
Rated voltage: 230V
~
50 Hz
Nominal speed: n
0
6,000 - 11,000 min
-1
Nom. oscillation speed: n
0
12,000 - 22,000 min
-1
Backing plate: 360° rotatable
Protection class: II /
Noise and vibration data:
Values determined in accordance with EN 60745.
The sound pressure level (A-weighted) of the
device is typically 71,4 dB(A). Uncertainty K=3 dB.
The sound level while working can exceed 85 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
= 2,309 m / s
2
Uncertainty K = 1,5 m / s
2
WARNING!
The vibration level given in
these instructions has been measured in accord-
ance with a standardised measurement procedure
specified in EN 60745 and can be used to com-
pare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may
exceed the values given in these instructions. It is
easy to underestimate the vibration load if the elec-
trical power tool is used regularly in particular
circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
I
D
:
0
0
0
0
0
2
1
4
3
2
General safety advice
WARNING!
Read all the safety advice and
instructions! Failure to observe the safety advice
and instructions may result in electric shock, fire
and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND
INSTRUCTIONS IN A SAFE PLACE FOR FUTURE
REFERENCE!
1. Workplace safety
a) Keep your working area clean and
clutter-free. Untidy or poorly lit working ar-
eas can lead to accidents.
b)
Do not work with the device
in potentially explosive en-
vironments in which there
are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
c)
Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.
Introduction / General safety advice