Kompernass PFBS 9 Power Hammer User Manual


 
9 GB/IE/CY
J Switch the charger off for at least 15 minutes
between successive charging processes. To do
this pull the mains plug
(
mains adapter
9
)
out
of the socket.
Q
Inserting / removing the
battery pack into / out of the
drill / grinder
Inserting the battery pack:
j Set the On / Off switch
1
to position “0”.
j Insert the battery pack
3
into the drill / grinder
until it engages.
Removing the battery pack:
j Pressing the battery pack buttons
2
at the
sides at the same time allows you to remove
the battery pack
3
.
Q
Changing a collet
j Press the spindle lock
7
and keep it pressed.
j Rotate the clamping nut
5
until the lock
engages.
j Release the clamping nut
5
from the thread
and remove the collet
18
.
j Insert the correct collet
18
and screw it tight
with the clamping nut
5
.
j Release the spindle lock
7
.
Q
Inserting / changing tools
j Press the spindle lock
7
and keep it pressed.
j Rotate the clamping nut
5
until the lock
engages.
j Release the clamping nut
5
using the open
spanner end
of the combination tool
23
.
j If a tool is already inserted remove it.
j First insert the tool you wish to use though the
clamping nut
5
before you insert it into the
collet
18
.
j Press the spindle lock
7
and keep it pressed.
j
Insert the collet
18
into the threaded insert and
screw
the clamping nut
5
tightly on the thread
using the
open spanner end of the
combination tool
23
.
Note: Use the screwdriver end of the
combination tool
23
to release or tighten the
screw of the mandrels
12
.
Q
Switching on and off / Setting
the speed range
Switching on / Setting the speed range:
j Set the On / Off switch
1
to a position
between “2” and “10”.
Switching off:
j Set the On / Off switch
1
to position “0”.
Q
Advice on working with
materials / Tools / Speed ranges
j Make sure that no debris from working the
material adheres to the tool. Use paraffin, cut-
ting oil or similar medium to lubricate the tool.
j Use the highest speed when working on steel
or iron with the milling bits.
j Use a short trial on a test piece to determine the
optimum rotational speed range for working on
zinc, zinc alloy, aluminium, copper and lead.
j Use the low speed range for working on plas-
tics and low-melting point materials.
j Use high speeds on wood.
j Use the medium speed range for cleaning,
polishing and buffing.
The following information shall be considered as
recommendatory only. Learn by practical experi-
ence which tools and settings are the best for the
materials you work with.
Operation