Filter
Top Products
10 GB/IE/CY
Example of
material
DIN guidance
value
Car body paint 16-20 DIN-sec
Acrylic paint 25-30 DIN-sec
Synthetic resin paint 25-30 DIN-sec
Primer 25-30 DIN-sec
Q
Switching On/Off
Switching on
j To start the device, press the ON/OFF switch
3
and keep it pressed.
Switching off
j To switch off the device, release the ON/OFF
switch
3
.
Q
Spraying process
The surface to be sprayed must be clean, dry and
free of grease.
Observe the safety advice!
1. You can vary the spray by adjusting the regulator
button
2
(see Fig. D). The spray is correctly
set when no drops are formed and the gun
produces a fine, consistent spray pattern.
2. Do not switch the device on or off over the
area being sprayed. Begin and end the spray
process approx. 10 cm beyond the area being
sprayed.
3. The spray process should follow the sequence
shown in Fig. E – keep the spray gun moving
parallel to the surface
– Do not incline the spray gun
– Move the spray gun at a constant speed
– Apply the sprayed medium as thinly as possible
– The layer(s) of sprayed medium need(s) to
be allowed to dry for some time before you
apply the next coat Fig. F) at right angles to
the previous coat.
4. Do not allow the paint cup to empty complete-
ly while spraying – drops may form!
Q
Maintenance and cleaning
General advice
1.
WARNING!
Pull out the mains plug be-
fore you carry out any tasks on the spray gun.
Do the same when you take a break from spraying.
2. After each use, spray thinners (in the open
air only – danger of explosion!) or
water through the device.
3. To protect from rust after cleaning, you can
spray sewing machine oil through the device.
4.
WARNING!
Never immerse the device
in the cleaning medium.
5. Never use inflammable solvents to clean the
device.
Cleaning instructions
1. Unscrew the attachment screw
1
, see Fig. A.
2. Take off the pump housing
10
downwards.
3. Unscrew nozzle
8
and remove the suction-
pressure valve
9
.
4. Take the pump piston
4
and spring
5
out of
the pump housing
10
.
5. Clean parts
4
,
5
,
8
,
9
with thinners.
6. Fit the components back in reverse order.
Q
Disposal
The packaging is wholly composed of
environmentally-friendly materials that can
be disposed of at a local recycling centre.
Do not dispose of electrical
power tools with the household
rubbish!
In accordance with European Directive 2002 / 96 / EC
(covering waste electrical and electronic equipment)
and its transposition into national legislation, worn
out electrical power tools must be collected separately
and taken for environmentally compatible recycling.
Contact your local refuse disposal authority for
more details of how to dispose of your worn out
electrical devices.
Advice on use / Maintenance and cleaning / Disposal