Kompernass PSBM 1100 Drill User Manual


 
8 GB/IE
Safety
Safety
Safety advice relating
specifically to this device
J Keep children away from the device.
Store the device indoors in an en-
closed, dry place where it cannot
be reached by children.
To avoid danger to life from
electric shock:
J
Frequently check the condition of the
device, mains lead and plug. Do not
use the device if these kinds of parts
are damaged. Never open up the device. Always
have any repairs carried out or replacement
parts fitted at the service centre or by an elec-
trical equipment repair specialist. A damaged
device, mains lead or plug presents a serious
danger to life from electric shock.
J Have repairs carried out only by an electrician
or your service centre.
J Do not touch the mains lead if it becomes
damaged or cut through while you are using
the device. Pull the plug out of the mains socket
immediately and have the device repaired by
a suitably qualified person or at your service
centre.
J
Do not operate the device if it is
damp and do not use it in a damp
environment.
J If you use the device outdoors, always connect
it through a residual current device (RCD) with
a maximum trip current of 30 mA. If using an
extension lead, always use one that is ap-
proved for outdoor use.
J Do not use the device in rain or in wet conditions.
J Do not work in areas where there may be
hidden electricity cables or gas or water pipes.
Use a suitable detector or ask your local utility
service providers. Contact with electricity cables
can lead to fire or electric shock. Damaging a
gas pipe can lead to an explosion. Penetration
of a water pipe can lead to property damage
or to electric shock.
Attention! To avoid the risk
of injury:
J
Wear protective glasses, hearing
protection (noise can lead to hearing
loss), dust protection mask and
protective gloves. Please note that working on
stone or metal can give rise to hazardous dusts
that can adversely affect your health.
J Be particularly careful when screwing in longer
screws - the driver could slip off the screw head.
J Use the auxiliary handle supplied with the device.
Loss of control of the tool can lead to injury.
JSecurely support the workpiece. Use clamps or
a vice to grip the workpiece firmly. This is much
safer than holding it in your hand and it means
you then have both hands free to operate the
electrical power tool.
Working safely!
J If a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
J Never use the device for a purpose for which it
was not intended.
J Before you insert the mains plug into the socket,
always check that the device is switched off.
J Always keep proper footing and balance.
J When taking a break from your work, before
carrying out any tasks on the device itself and
when you are not using the device, always pull
the mains plug out of the mains socket.
J Handle the device carefully and treat it with
respect. Always keep the device clean, dry
and free of oil or grease.
J Remain alert at all times! Always watch what
you are doing and proceed with caution.
J Do not use the device if you cannot concen-
trate or you are feeling unwell.