7 GB/IE/CY
5
Rotation direction switch
6
Gear selector switch
7
Auxiliary handle
8
Quick-release chuck
9
Depth stop
Q
Included items
1 Hammer-action drill PSBM 850
1 Auxiliary handle
1 Depth stop
1 Carry case
1 Operating instructions
1 „Warranty and service“ booklet
Q
Technical data
Nom. voltage: 230 V
~
50 Hz
Rated power: 850 W
No-load rotational
speed: 1st gear max. 1450 min
–1
2nd gear max. 3400 min
–1
Impact cycles: 16 times rotation speed
Chuck:
Chuck capacity: 1.5 – 13 mm
Drilling in steel: max. ø 13 mm
Drilling in wood: max. ø 30 mm
Impact drilling in
concrete: max. ø 16 mm
Screwing in wood: max. ø 8 mm
Screwing in sheet steel: max. ø 6.3 mm
Protection class: II /
Noise and vibration data:
Values determined in accordance with EN 60745.
The sound pressure level (A-weighted) of the
device is typically 90 dB(A). Uncertainty K = 3 dB.
The sound level while working can exceed 101 dB (A).
Wear ear protection!
Impact drilling in concrete:
max. Vibration emission value
a
h, ID
= 14.718 m / s
2
Uncertainty
K = 2.705 m / s
2
Drilling in metal:
max. Vibration emission value
a
h, D
= 2.363 m / s
2
Uncertainty
K = 1.5 m / s
2
WARNING!
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to underes-
timate the vibration load if the electrical power tool is
used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actual-
ly in use. This can result in a much lower vibration
load over the whole of the period of working.
I
D
:
0
0
0
0
0
2
1
4
3
7
Introduction