Filter
Top Products
SWITCHING ON AND OFF
When using the orbital sander you can select between continuous and non-continuous operation (see Fig. ቱ). For short periods of sanding
use the non-continuous setting and for longer periods use the continuous setting. Select your chosen setting as follows:
SWITCH ON NON-CONTINUOUS OPERATION: press ON/OFF switch
ቩ.
SWITCH OFF NON-CONTINUOUS OPERATION: release ON/OFF switch
ቩ.
SWITCH ON CONTINUOUS OPERATION: press ON/OFF switch
ቩ and with it still pressed fix it in place
by pressing the continuous operation locking button
ቫ.
SWITCH OFF CONTINUOUS OPERATION: press on/off switch
ቩ and release it again.
SETTING THE SPEED
You can set the required speed using the adjuster wheel ቪ (see Fig ቱ) as required. As the setting depends on what kind of material
you are working with, use the recommendations and examples given in Tips and Tricks.
FITTING THE SANDING SHEETS
Note: before fitting a new sanding sheet, remove dust and dirt from the base ቤ.
1. Lift both clips
ቢ to open them to insert a new sanding sheet or change the sanding sheet for use on a different material.
2. Push the sanding sheet
ባ under the open clip at one end and clamp it securely on the base by moving the clip down again.
3. Do the same at the other end. Make sure that the sanding sheet
ባ is tight against the base. See Figures ቮ and ቯ.
4. Important! - The holes in the sanding sheet
ባ and the base ቤ must align for the dust to be extracted through the base. See Figure ተ.
Different materials need different grades of sanding sheets. To determine which grade is suitable for your work, please read our
recommendation in Tips and Tricks.
DUST EXTRACTION
• DUST EXTRACTION WITH PAPER DUST BAG
Push the paper dust bag ቧ on to the adapter ቦ. Ensure that the adapter fits correctly into the holder. Clip the dust bag with the adapter
to the side of the sander.
• DUST EXTRACTION WITH VACUUM CLEANER
For dust extraction using a vacuum cleaner use the appropriate connector – see Figure ቭ. Attach the adapter to the end of the vacuum
cleaner hose and clip it to the side of the equipment.
5