Filter
Top Products
10 GB/IE
Original ancillaries / and
accessories
J Only use accessories and tools that are specified
in the operating instructions. The use of tools
and accessories other than those recommended
in the operating instructions could lead to an
increased risk of personal injury for you.
Any questions?
J You may begin the work once you have famil-
iarised yourself with the instructions, functions
and handling of the appliance. The safest work
is possible by heeding all information and
instructions of the manufacturer.
Operation
Operation
Take note of the mains voltage! The voltage must
agree with the information on the type plate of the
appliance (appliances that are designated as 230 V
can also be connected to 220 V).
Switching On and Off
Switching on intermittent function:
j Press the ON / OFF switch
1
.
Switching off intermittent function:
j Release the ON / OFF switch
1
.
Switching on continuous operation :
j Press the ON / OFF switch
1
, hold it pressed
and press the locking button
2
.
Switching off continuous operation:
j Press the ON / OFF switch
1
then release it
again.
Setting the oscillation speed
You can set the desired oscillation speed as
needed with the oscillation speed selector
10
.
The required oscillation speed depends on the
material being worked and can be determined
through practical tests.
Attaching a sanding pad
m Warning! Before performing work on the
appliance, always disconnect the power.
Note: Before attaching a new sanding pad
9
,
remove dust and dirt from the sanding plate
8
.
1. Open the two tensioning levers
7
by pushing
them up to clamp in a new sanding pad
9
or
when switching the sanding pads
9
for the
use with different material.
2. Slide the sanding pad
9
at one end under the
clamping bar
6
above the sanding plate
8
and clamp it tightly by pressing the tensioning
lever
7
back down.
3. Do the same at the other end. Make certain
that the sanding pad
9
rests firmly against the
sanding plate
8
. See also Fig. B and C.
4. Important! To ensure that vacuuming of dust
through the sanding plate
8
is guaranteed,
the holes in the sanding pad
9
and the
sanding plate
8
must match up.
Various materials require different grit values. You
can read which grit value is best suited for which
work in our recommendations under "Tips and tricks".
Vacuuming dust
m Warning! Fire hazard! A risk of fire exists
when working with electrical appliances that have
a dust collection box
4
or can be attached to a
vacuum cleaner via an external suction adapter!
Under unfavourable conditions, such as flying
sparks, grinding of metal or metal remnants in
wood, the wood dust in the dust sack (or in the dust
bag of a vacuum cleaner) can ignite. This can
Safety Instructions / Operation