Kramer Electronics T5F-13 Work Light User Manual


  Open as PDF
of 2
 
Inserting Pass-through Cables
To insert the pass-through cables (for example, to connect a laptop) do the following:
1. Remove the two screws attaching the split pass-through bracket.
2. Remove the split grommet(s).
3. Insert the cable(s) through the rectangular opening.
4. Open the split grommet slightly and insert the required cables.
5. Place the split bracket around the grommet and position this assembly over the inner
frame.
6. Place the two screws appropriately and tighten the split bracket together with the
grommet and inserted cables to the inner frame.
7. Insert the self-locking ties through the tie holes to secure the cables to the inside walls
of the enclosure.
Adjusting the Height of the Inner Frame
If needed, you can adjust the inner frame height to accommodate large or bulky cables. To
adjust, perform the following:
1. Remove the height adjustment screws, while supporting the frame from underneath with
your fingers.
2. Raise or lower the connecting surface to the required height, insert the screws, and
tighten them in place.
KRAMER ELECTRONICS LTD.
Installation
Instructions
MODEL:
T5F-13
Inner Frame
For the latest information on our products and a list of Kramer
distributors, visit our Web site where updates to this user manual may be
found.
We welcome your questions, comments, and feedback.
Web site:
E-mail:
www.kramerelectronics.com
info@kramerel.com
!
SAFETY WARNING
Disconnect the unit from the power
supply before opening and servicing
P/N: 2900-300072 Rev 2
 previous