Filter
Top Products
Cutting Sheet Goods
1. Adjust the hold down plate according to the
width of material to be cut.
2. Lay the workpiece onto the table and up against
the saw fence.
3. Slide the workpiece through the saw blade until
the material engages the hold down plate. Walk
the workpiece through the cut with the sliding table
until the workpiece clears the saw blade and the
cut is completed.
Cross Cutting
For cross cutting panels and narrow stock, position
the miter fence onto the sliding table carriage as
shown. Tighten lock knobs. (Fig. 24)
Making sure that table lock is disengaged, postion
the workpiece against the miter fence and push
sliding table through the cut.
Miter Cuts
Loosen the lock knob on the right side of the
miter fence (closest to blade) slightly and use as a
pivot point. Loosen the lock knob on the left side of
the miter fence and position the miter fence to the
desired angle using the scale on the sliding table
carriage. (Fig. 25)
14
Operation
Figure 25
Figure 23
Figure 24