Filter
Top Products
18
Functions
Leica DISTO™ D330i 776751 en
D
EN
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
H
RUS
CZ
down over the ideal target point.
Press to stop continuous measurement (2). The
value is adopted. Aim at the lower point and
press this button to trigger the measurement
(3). The result is displayed in the summary line, the
partial results in the secondary lines.
Indirect measurement - determining a chain
value using 3 measurements
e.g. determining the height between point 1 and
point 2 using three target points.
Press this button six times; the display shows
the following symbol . The laser is switched on.
Aim at the upper point (1).
Press this button and trigger the measurement.
After the first measurement is recorded and shown
onscreen, the display flashes (2).
Triggers the measurement. After the second
measurement is recorded and shown onscreen, the
display flashes (3).
Press and hold down this button to trigger
continuous measurement. Sweep the laser up and
down over the ideal target point.
Press this button to end continuous measure-
ment. The result is displayed in the summary line, the
partial results in the secondary lines.
Storage of constants/historical
storage
Storage of a constant
You can store and recall a frequently used value e.g.
height of a room. Measure the desired distance,
press and hold the button until the device beeps
to confirm storage.
Recalling the constant
Press this button once to recall the constant
and make it available for further calculations by
pressing button .
12
3