Lenmar Enterprises BCR-467 Battery Charger User Manual


  Open as PDF
of 3
 
1. DC Power Input Jack - AC
Adaptor or Car Cigarette
Lighter Adaptor
4. JVC/Panasonic
/Hitachi/RCA 9.6 / 10V Batt
7. Panasonic/Sony/Hitachi
/JVC/RCA 4.8/6V Batt.
2. Sony 7.2 Volt Li-Ion
Battery
5. AA / AAA Battery (x4) 8. Adjustable Sliding Plate
3. Charge Indicator 6. Canon 6VBattery 9. Discharge Button
The charger unit will beep once to verify the battery is making proper contact and will begin to charge the
battery. The charge indicator on the side of the unit will show the progress of the charge.
mll ð mml ð mmm ð llm
0-33% 33-66% 66-99% Full
( l = OFF m = ON )
The charger will automatically stop the charge and beep 3 times when a full charge is detected on the
battery. The charge indicator will show only 1 Red light to indicate the battery has reached full charge. The
time required to reach a full charge will vary depending on the capacity of the battery and how much charge
is already in it before you start.
NOTE
: Due to the special properties of Li-Ion batteries, the charge indicator may not accurately indicate the
actual status of the battery as it charges and the charger may seem to be turning on and off by itself after
the battery has reached a full charge. When this happens, the battery is ready for use, and should be
removed.
DISCHARGE / CHARGE MODE (for Ni-Cd type batteries)
Plug the appropriate adapter into the base module, and insert the battery to be charged. Once the charger
beeps to indicate that the battery is properly connected, press the Discharge button on the side of the unit.
The unit will beep 2 times and the green Discharge light will go on. The DISCHARGE light will stay on until
the battery is fully discharged, then the charger will switch automatically into the charge mode and charge
the battery fully.
NOTE: You should only use the Discharge feature with a Ni-Cd type battery. Discharging other type
batteries may cause damage.
SPECIFICATIONS:
P
P
O
O
W
W
E
E
R
R
S
S
O
O
U
U
R
R
C
C
E
E
· AC Adapter - Output 14 VDC - 800mA, UL/CSA Approved
· 12 Volt DC Cigarette Adapter - Not to exceed 18 VDC
C
C
H
H
A
A
R
R
G
G
I
I
N
N
G
G
C
C
I
I
R
R
C
C
U
U
I
I
T
T
· Microprocessor Controlled Compatible with Ni-Cd, Ni-MH, Li-Ion, Lead Acid, NoMEM
· AutomaticVolt. Select. (4.8V / 6V / 7.2V / 9.6V/10V)
· Current: AA/AAA type - 200mA, Sony 7.2V NP-500 type - 200mA, others - 780mA
 previous