Lightolier 7589AZ Work Light User Manual


 
I
(
A.
B.
c.
D.
INSTRUCTIONS FOR LYTESPAN ATTACHMENT FITTING
INSTRUCTION SHEET NO
lS:7589AZ
ROW
/- SILVERED CONTACT
CORD PENDANT MOUNTING
(supports up to 10 Ibs.)
I. Unscrew LEVER. Remove PLUG ASSEMBLY, HOUSING
INSERT from attachment HOUSING. See Fig. 1.
2. See “WIRING PROCEDURE” below.
STEM MOUNTING USING 1/2” O.D. TUBING
(supports up to 25 Ibs.)
I. Unscrew LEVER, STRAIN RELIEF CAP and KNURLED
RING Remove PLUG ASSEMBLY, HOUSING INSERT
from attachment HOUSING.
2. Use STEM TUBING with M-18 pipe thread
3A” long (not supplied). Screw KNURLED RING onto
STEM TUBING. See Fig. 1A.
3. Insert STEM TUBING into attachment
HOUSING and screw on LOCKNUT until secure.
Tighten KNURLED RING to lock in place.
4. See “WIRING PROCEDURE’’ below.
CHAIN MOUNTING
(supports up to 25 Ibs..)
1.
Unscrew LEVER and STRAIN RELIEF CAP.
Remove PLUG ASSEMBLY, HOUSING INSERT from
attachment HOUSING.
2. Replace STRAIN RELIEF CAP with %-18 CHAIN LOOP
(not supplied). See Fig. lB.
3. See “WIRING PROCEDURE” below.
WIRING PROCEDURE
1.
2.
3.
4.
5.
Remove 2“ of outer insulation from FIXTURE CORD
(when required) and strip conductor ends 3A”. See Fig. 1.
Insert FIXTURE CORD through attachment housing.
Fasten BLACK WIRE to LONGER (BRASS) CONTACT and
WHITE WIRE to SHORTER (SILVERED) contact. For
3 conductor cord, splice GROUND LEADS with wire
connector. (If the GROUND LEAD from the attachment
HOUSING is not used, leave wire connector on.) See Fig. t
CAUTION: OBSERVE POLARITY WHEN
FASTENING WIRES. BEND WIRES AROUND
SCREW IN CLOCKWISE DIRECTION.
Pull FIXTURE CORD back through attachment HOUSING and
push HOUSING INSERT and PLUG ASSEMBLY into
HOUSING (silvered contact in PLUG ASSEMBLY facing
grooved side of attachment HOUSING). Push ground leads
into area between SPRING section. Fig. 2.
Allow fixture cord to extend into attachment HOUSING by
1/6” and tighten PLASTIC SET SCREW, Fig. 2.
CAUTION: TIGHTEN ENOUGH TO SUPPORT
ASSEMBLY.
Screw LEVER into PLUG ASSEMBLY.
‘RASSCoNTACT----kc <
f
‘“~ :::~;
,SJQ/
GREEN GROUND
!
1
“~F’=
LEAD
\
>;,
PLUG ASSEMBLY
$3 ~i
w,,,-’”
CONNECTOR
‘REEN ‘ROuND --=&
LEAD
KNURLED RING
STRAIN RELIEF
CAP
$3W27 /’-LEvER
SET SCREW
~ ~,xTuRE
CORD
FIG. 1
KNURLED
RING
*
CHAIN s<
LOOP
8
KNURLED
(by others)
~ sT~~
TUBING
STEM
MOUNTING
CHAIN
MOUNTING
GROOVE
LEVER
TIC SET
FIXTURE
CORD
--’4 l\
SCREW
~ ~ > STRAIN RELIEF
CAP
FIG. 2
‘@ SECAUCUS, NEW JERSEY, 07096 ”0508
[m[<>[=[~<>[ml[~l~ MONTREAL, QUEBEC, CANAD~