Filter
Top Products
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:8292CY
A0400 Page 2 of 2
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
®
INSTRUCTIONS FOR THE INSTALLATION AND OPERATION OF PowerArc
™
CANOPY FIXTURE
INSTRUCTIONS FOR LAMPING A PowerArc
CANOPY FIXTURE:
1. Turn off power to fixture.
2. Remove the LENS by inserting finger into SLOT A and
pressing the LENS in the direction of SLOT B (See FIG. 5).
3. Carefully rotate LENS out of SLOT A in the direction shown
in FIG. 6.
4. Slide glass out of SLOT B by pulling the LENS in the
direction of SLOT A (See FIG. 7).
5. To insert LAMP (70W CDM or CMH T-6 Double Ended
Metal Halide M85), carefully push one end of the LAMP
CONTACT into one end of the SOCKET CONTACT until
the other end of the LAMP can be inserted into the
opposite SOCKET (See FIG. 8).
WARNING: ACCORDING TO MANUFACTURER’S
INSTRUCTIONS, LAMP SHOULD BE INSERTED
IN THE SOCKET WITH A MINIMUM ANGLE
OTHERWISE BENDING FORCES WILL RESULT IN
LAMP BREAKAGE. ALSO, INSTALL LAMP USING
PROTECTIVE PAPER AND DO NO REMOVE IT
UNTIL INSTALLATION IS COMPLETE. IF LAMP IS
TOUCHED WITH BARE HANDS, CLEAN LAMP
WITH DENATURED ALCOHOL AND WIPE WITH
LINT FREE CLOTH.
6. Insure both LAMP CONTACTS are properly seated into the
SOCKET CONTACTS (See FIGS. 8 & 9).
7. To re-insert LENS: First insert LENS in SLOT A (side with no
switch), carefully push the LENS until you can set it flat into
the face of the fixture. Make sure it presses the INTERRUPT
SWITCH, then engage LENS into SLOT B.
WARNING: IF USED IMPROPERLY, THIS LAMP
CAN CAUSE SERIOUS SKIN BURN AND EYE
INFLAMMATION FROM SHORTWAVE ULTRAVIO-
LET RADIATION. DO NOT OPERATE FIXTURE
WITHOUT PROTECTIVE LENS IN PLACE. FIXTURE
IS EQUIPPED WITH A POWER INTERRUPT SWITCH
TO PREVENT LAMP FROM BEING ENERGIZED
WHEN LENS IS REMOVED (SEE FIG. 5). DO NOT
ATTEMPT TO DISABLE THIS DEVICE.
LENS SLOT A SLOT B
LAMP
CONTACT
SOCKET
SOCKET
CONTACT
LAMP
LAMP
SOCKET
FIG. 5
FIG. 6
FIG. 7
FIG. 8
FIG. 9