Filter
Top Products
LIFTING
The machine weighs approximately 374 kg. (824 lbs)
with a full tank of fuel. A lift bail is mounted to the
machine and should always be used when lifting the
machine.
HIGH ALTITUDE OPERATION
At higher altitudes, output derating may be necessary. For max-
imum rating, derate the machine 2.5% to 3.5% for every 305m
(1000ft.). Due to new EPA and other local emissions regula-
tions, modifications to the engine for high altitude are restricted
within the United States and some European Countries. Use
above 1828m (6000 ft.) may be limited due to poor engine per-
formance or excessive exhaust smoke. An authorized Kubota
engine field service shop should be contacted to determine if
any adjustments can be made for operation in higher elevations
locally.
HIGH TEMPERATURE OPERATION
At temperatures above 40°C,welder output derating is neces-
sary. For maximum output ratings, derate the welder output 2
volts for every 10°C above 40°C.
Cold weather starting:
With a fully charged battery and the proper oil, the
engine should start satisfactorily down to about -15°C
(5°F). If the engine must be frequently started at or
below -5°C (23°F), it may be desirable to install cold-
starting aides. The use of No. 1D diesel fuel is recom-
mended in place of No. 2D at temperatures below
-5°C (23°F). Allow the engine to warm up before
applying a load or switching to high idle.
Note: Extreme cold weather starting may require
longer glow plug operation.
Under no conditions should ether or other starting
fluids be used!
------------------------------------------------------------------------
WARNING
A-2
INSTALLATION
RANGER® 305D (CE)
A-2
SAFETY PRECAUTIONS
Only qualified personnel should install,
use, or service this equipment.
LOCATION AND VENTILATION
The welder should be located to provide an unrestrict-
ed flow of clean, cool air to the cooling air inlets and to
avoid restricting the cooling air outlets. Also, locate the
welder so that the engine exhaust fumes are properly
vented to an outside area.
STACKING
RANGER® 305D (CE) machines cannot be stacked.
ANGLE OF OPERATION
Engines are designed to run in the level condition
which is where the optimum performance is achieved.
The maximum angle of continuous operation is 20
degrees in all directions, 35 degrees Intermittent (less
than 10 minutes continuous) in all directions. If the
engine is to be operated at an angle, provisions must
be made for checking and maintaining the oil level at
the normal (FULL) oil capacity in the crankcase.
When operating the welder at an angle, the effective
fuel capacity will be slightly less than the specified 45
liters (12 gallons).
Do not attempt to use this equipment until you
have thoroughly read the engine manufacturerʼs
manual supplied with your welder. It includes
important safety precautions, detailed engine
starting, operating and maintenance instructions,
and parts lists.
------------------------------------------------------------------------
ELECTRIC SHOCK can kill.
•
Do not touch electrically live parts or
electrode with skin or wet clothing.
• Insulate yourself from work and
ground
• Always wear dry insulating gloves.
------------------------------------------------------------------------
ENGINE EXHAUST can kill.
•
Use in open, well ventilated areas or
vent exhaust outside.
------------------------------------------------------------------------
MOVING PARTS can injure.
•
Do not operate with doors open or
guards off.
• Stop engine before servicing.
• Keep away from moving parts.
------------------------------------------------------------------------
See additional warning information at
front of this operatorʼs manual.
WARNING
• Lift only with equipment of ade-
quate lifting capacity.
• Be sure machine is stable when lift-
ing.
• Do not lift this machine using lift
bail if it is equipped with a heavy
accessory such as trailer or gas
cylinder.
FALLING • Do not lift machine if lift bail is
EQUIPMENT can damaged.
cause injury. • Do not operate machine while
suspended from lift bail.
--------------------------------------------------------------------------------
WARNING