Filter
Top Products
'(*,!'&
$&R(!(
('/*-(+)-&
All of the LED’s will briefly illuminate during power-up.
If the gun trigger is activated during power up, the
feeder will not operate until the gun trigger is released.
/!*+(%(*!+($0
!6>7
The left display shows the preset I;D78776EB776.
The right display shows '.. The wire feed speed
LED is lit.
/7>6;@9
The value in the left display will be either 3?BE or
actual I;D78776EB776, depending upon the selection
chosen in the set-up menu. The corresponding LED
below the display will light. Note that actual WFS may
not match preset WFS, if welding at low voltages with
high wire feed speeds. The right display shows the arc
HA>F397. If the wire feeder is connected for electrode
negative welding, then the voltage display shows a
minus sign.
8F7D/7>6;@9
The display continues to hold the value of the 3?B7D
397 or /+ and 3D5HA>F397 for five seconds after
welding stops. The 3?B7D397 or /+ and HA>F397
displays flash.
+,-(%&-
(D7B3D3F;A@8AD/+3>;4D3F;A@
• Place the CV/CC switch in CV.
• Set the display to the desired wire feed speed
(example: 400 inches per minute)
• Measure the actual wire feed speed (example: 405
inches per minute)
• Place the WFS knob in the 12 o’clock position.
(D7B3D3F;A@8AD?B7D3973>;4D3F;A@
Connect the feeder to a power source and grid.
Adjust the power source and grid to the desired
amperage. (example: 220 Amps)
Record the amperage display on the wire feeder.
(example: 210 amps)
To enter the set-up menu, use paper clip to press the
small button located on the case front.
A
VERTISSEMENT
AV
WFS
A
VERTISSEMENT
AV
WFS
AVERTISSEMENT
AV
AMPS
VOLTAGE
AVERTISSEMENT
AV
AMPS
VOLTAGE
BUTTON
BUTTON