Filter
Top Products
B-2
OPERATION
LN™-23P
B-2
2. Remove compartment cover along with plastic wire
reel brake and reel cover. Pull wire end from spool
and route it through the liner opening that is mount-
ed inside the wire reel case.
3. Pull 2-3 ft. of wire through upper conduit cable
piece as shown in picture below.
ELECTRIC SHOCK can kill.
• Do not touch electrically hot parts.
5. Turn on power and trigger the gun to take up slack
in the wire.
6. Connect the upper conduit and lower Conduit
pieces as shown in picture below.
Reel Cover
2-3 Feet
Feed Wire thru
Liner Opening.
WARNING
Watch for kinks when
feeding wire thru conduit.
Upper and Lower conduit.
4. Add Reel Cover. Form a loop with the wire and
route it through the lower conduit piece and past
the drive rolls as shown below .
Feed into Drive
Rolls in this area.
Loop
Enter Wire thru conduit piece
Add Reel Cover
INSTRUCTIONS FOR LOADING WIRE
INTO LN™-23P
(For machines that have code numbers Higher
than 11384.)
1. With the power shut off and input leads going to the
wire feeder disconnected, lay LN™-23P down with
wire reel facing up.