Filter
Top Products
LN-25
E-2
TROUBLESHOOTING
PROBLEMS
(SYMPTOMS)
No wire feed when gun trigger is
pulled
POSSIBLE AREAS OF
MISADJUSTMENT(S)
1. Power source must be on
and open circuit voltage
(OCV) present at weld
terminals.
2. LN-25 work clip may not be
connected.
3. LN-25 polarity switch must
match electrode polarity.
4. Jumper plug on control or
option board may be loose
or missing.
5. The power source O.C.V.
must be above 15 VDC. But
not more than 110 VDC.
6. The gun trigger may be
faulty.- Replace gun.
Wire feeds for a short time but
stops feeding. When gun trigger
is released and retriggered wire
feeding starts but stops again.
1. The drive motor may be
overloaded. Check the wire
feeding system. EX. Drive
roll tension, reel brake and
gun cable liner.
Wire feeds OK, but stubs or
stops while welding.
1. If the power source is a
constant current type
supply the arc voltage may
be “dipping” below 15 VDC
causing the LN-25 to stop
or hesitate.
2. Connect a constant voltage
type power supply to the
LN-25.
3. Make sure wire-feed mode
switch (S3) is in the proper
position.
RECOMMENDED
COURSE OF ACTION
FEEDING PROBLEMS
Contact your local
Lincoln Authorized
Field Service Facility
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely,
contact your local authorized field service facility for technical troubleshooting assistance before you proceed.
CAUTION