Filter
Top Products
16
TROUBLESHOOTING
16
SQUARE WAVE TIG 175
Observe all Safety Guidelines detailed throughout this manual
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local
Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
CAUTION
TIG WELDING PROBLEMS
PROBLEMS
(SYMPTOMS)
POSSIBLE AREAS OF
MISADJUSTMENTS(S)
RECOMMENDED
COURSE OF ACTION
Black areas along weld bead.
Weak high frequency - machine has
normal welding output.
High frequency “spark” is present at
tungsten electrode, but operator is
unable to establish a welding arc.
Machine has normal open circuit
voltage (refer to
Technical
Specifications
in the Installation
Chapter).
1. Clean any oily or organic conta-
mination from the work piece.
2. Tungsten electrode may be cont-
aminated. Replace or sharpen.
3. Check for contaminated gas or
leaks in the gas line, torch, or
connections
4. Gas shielding may be insuffi-
cient. Increase gas flow; reduce
tungsten stickout beyond gas
cup.
1. Check for poor connections in
the welding circuit.
2. Gas shielding may be insuffi-
cient. Increase gas flow; reduce
tungsten stickout beyond gas
cup.
3. Check for work and electrode
cables in poor condition allowing
high frequency to “Leak Off”.
4.
Keep cables as short as possible
.
5. Check Spark Gap operation and
setting (0.015”)
1. The tungsten electrode may be
contaminated. Replace or sharp-
en.
2. The current control may be set
too low.
3. The tungsten electrode may be
too large for the process.
4.
If a helium blend is used as a
shielding gas, then reduce the
percentage of helium.
Contact your Local Lincoln Authorized
Field Service Facility for technical
troubleshooting assistance.