Filter
Top Products
A-2 A-2
INSTALLATION
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the Welder
from its carton and remove all packing material
Remove the following loose items from the carton
(see Figure A.1):
1. WELDMARK 135 PLUS
2. Gun and cable assembly
(1)
3. Literature and miscellaneous including:
a) This operating manual
b) A contact tip for .030” (0.8 mm) diameter wire.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. Sample Spool of Super Arc L-56 .025 MIG Wire.
7. Adjustable mixed-Gas Regulator & Hose.
For available options and accessories refer to the
accessories section later in this manual.
1)
As shipped from the factory, the welding gun is
ready to feed .023 or .025 (0.6 mm) wire.
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the WELDMARK 135 PLUS
Operating Manual should install and oper-
ate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The WELDMARK135 PLUS power switch is
to be in the OFF (“O”) position when
installing work cable and gun and when
connecting power cord to input power.
WARNING
FIGURE A.1
1
2
3
4
5
WEL
DI
N
G
AM
P
RANG
E
2
5
-
1
2
5
6
7
WELDMARK 135 PLUS