Filter
Top Products
A-2
A-2
INSTALLATION
SAFETY PRECAUTIONS
Read entire installation section before starting
installation.
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the Pro-MIG
175 from its carton and remove all packing material
around the Pro-MIG 175. Remove the following loose
items from the carton (see Figure A.1):
1. Pro-MIG 175
2. Gun and cable assembly
(1)
3. Literature and miscellaneous including:
a) This operating manual
b) 2 extra .023"-.025” (0.6 mm) contact tips
c) 3 extra .035” (0.9 mm) contact tips
d) Hex key wrench for removal of drive roll.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. a) 2 lb. spool of .025” (0.6 mm) Super Arc L-56
MIG wire.
b) Sample spool of Innershield .035” (0.9 mm)
NR-211-MP.
7. Hand shield with filter plate and lens.
8. Adjustable mixed-Gas Regulator & Hose.
9. Instructional video.
10. Gasless Nozzle.
For available options and accessories refer to the
Accessories Section of this manual.
1)
As shipped from the factory, the Pro-MIG 175 gun liner is
ready to feed .023” (0.6 mm) -.035 (0.9 mm) wire. The
contact tip is sized for .023”-.025” (0.6
mm) wire.
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the PRO-MIG 175 Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The PRO-MIG 175 power switch is to be in
the OFF (“O”) position when installing
work cable and gun and when connecting
power cord to input power.
WARNING
FIGURE A.1
1
2
3
4
6
7
8
5
9
10
Pro-MIG 175