Filter
Top Products
INSTALLATION
CLASSIC 300D KUBOTA
A-1
A-1
TECHNICAL SPECIFICATIONS - CLASSIC 300D KUBOTA
Make/Model Description Speed (RPM) Displacement Starting Capacities
System
4 Cylinder
4 Cycle 134.1 cu. in
12VDC battery
Fuel: 15 gal.
Naturally Aspirated (2.2 ltrs) (Group 24, 650 57 L
Kubota Water-Cooled High Idle 1800 cold crank amps)
V2203M Diesel Engine Low Idle 1400 Bore x Stroke
1.4 KW
Starter Oil: 8.0 Qts.
Cast Iron Cylinder, Full Load 1800 40 A. Alternator 7.6 L
Block/Crankcase 3.43” x 3.64” w/ built in reg. Coolant:
32.5HP @1800 RPM
9.5 Qts.
9.0 L
INPUT - DIESEL ENGINE
RATED OUTPUT @ 104°F(40°C) - WELDER
MODEL HEIGHT WIDTH DEPTH WEIGHT
K1643-5 CSA@ 1320 lbs.
With Out (599 kg)
Wire Feed Module
45.5 in. 24.00 in. 66.36 in.
K1643-6 CSA @ (1156 mm) (610 mm) (1686 mm) 1355 lbs.
With Wire Feed Module (615 kg)
RATED OUTPUT @ 104°F(40°C) - GENERATOR
DESCRIPTION RATED DC OUTPUT* Duty DC CURRENT RANGE
VOLTS @ RATED AMPS CYCLE
Fine Adjustments in each Range
40-350 Amps
220-Max.
300 Amp DC Welder 30V @ 250A 100% 160-240
All Copper Windings 32V @ 300A 60% 120-190
Pure DC Power Generator 99V DC Max. OCV @ 1800RPM 80-130
Min.-90
Auxiliary Power
(1)
3,000 Watts Continuous, 60 Hz AC
26 Amps @ 115V
13 Amps @ 230V
PHYSICAL DIMENSIONS
(2)
* Based on a 10 min. period.
(1)
Output rating in watts is equivalent to volt-amperes at unity power factor. Output voltage is within ± 10% at all loads up to
rated capacity. When welding, available auxiliary power will be reduced.
(2)
Height to top of exhaust elbow.