Filter
Top Products
A CLOSER LOOK
LN-15 Wire Feeder
www.lincolnelectric.com
[4]
NOTE:
A constant voltage (CV) power source is recommended for flux-cored arc welding (FCAW) and gas metal arc welding (GMAW) to obtain
code quality results. The LN-15 may be used with a constant current (CC) power source for non-critical applications where weld quality
and deposition properties are not critical.
Invertec
®
V350-PRO,
Invertec
®
V450-PRO
SAE 400 with CV adapter
Engine Driven Welders
with Wire Feed Module
(local mode and CV Adapter)
Magnum
®
gun and
cable assembly
Weld Power Cable
LN-15 semiautomatic
wire feeder
K1870-1
Output Terminals
Always Hot.
Work Clamp
CC Power Sources
Magnum
®
gun and
cable assembly
Weld Power Cable
LN-15 semiautomatic
wire feeder
K1870-1
Output Terminals
Always Hot.
Work Clamp
CV-400, CV-655, DC-400,
DC-600, DC-655,
Ranger
®
10,000,
Ranger
®
GXT,
Vantage
®
300,
Vantage
®
400,
Vantage
®
500,
Ranger
®
250,
Ranger
®
305G
Magnum
®
gun and
cable assembly
Weld Power Cable
LN-15 semiautomatic
wire feeder
K1870-1
Output Terminals
Always Hot.
Power source contactor
switch must be in the
“ON” position or use a
K484 Jumper Plug Kit.
(K484 required for CV-400)
Work Clamp
14 Pin
Typically used for general fabrication, maintenance and repair jobs because it's easy to set up and operate. Requires only one electrical
cable to the feeder – less to carry. Internal contactor standard on Across-The-Arc model.
Across-The-Arc Set-Up