Filter
Top Products
2
ENGLISH (Original instructions)
SPECIFICATIONS
Model DP3002 DP3003 DP4000 DP4001 DP4002 DP4003
Steel 10 mm 13 mm
Capacities
Wood 32 mm 38 mm
No load speed (min
-1
) 0 - 1,200 0 - 950 0 - 700
Overall length 304 mm 296 mm 304 mm 308 mm 304 mm 308 mm
Net weight 2.4 kg 2.2 kg 2.5 kg 2.4 kg 2.7 kg 2.5 kg
Safety class /II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END201-5
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ DOUBLE INSULATION
･ Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
ENE032-1
Intended use
The tool is intended for drilling in wood, metal and plastic.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
ENG905-1
Noise
The typical A-weighted noise level determined according
to EN60745:
Model DP3003
Sound pressure level (L
pA
) : 81 dB(A)
Sound power level (L
WA
) : 92 dB(A)
Uncertainty (K) : 3 dB(A)
Model DP4001,DP4002,DP4003
Sound pressure level (L
pA
) : 82 dB(A)
Sound power level (L
WA
) : 93 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model DP3003,DP4001,DP4002,DP4003
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).