Filter
Top Products
10
When cutting, move the tool with the straight guide flush with
the side of the workpiece. If the distance (A) between the
side of the workpiece and the cutting position is too wide for
the straight guide, or if the side of the workpiece is not
straight, the straight guide cannot be used. In this case,
firmly clamp a straight board to the workpiece and use it as a
guide against the router base. Feed the tool in the direction
of the arrow.
Templet guide (optional accessory)
The templet guide provides a sleeve through which the bit
passes, allowing use of the router with templet patterns.
To install the templet guide, loosen the screws on the tool
base, insert the templet guide and then tighten the screws.
Secure the templet to the workpiece. Place the tool on the
templet and move the tool with the templet guide sliding
along the side of the templet.
A
003261
003262
1. Screw
2. Base plate
3. Templet guide
12
3
003263
1. Bit
2. Templet guide
3. Base
4. Templet
5. Workpiece
1
2
3
4
5
003264