Filter
Top Products
7
Refer to the table to select the proper speed for the work-
piece to be cut. However, the appropriate speed may differ
with the type or thickness of the workpiece. In general, higher
speeds will allow you to cut workpieces faster but the service
life of the blade will be reduced.
CAUTION:
• The speed adjusting dial can be turned only as far as 5
and back to 1. Do not force it past 5 or 1, or the speed
adjusting function may no longer work.
The tools equipped with electronic function are easy to oper-
ate because of the following features.
Constant speed control
Electronic speed control for obtaining constant speed. Possi-
ble to get fine finish, because the rotating speed is kept con-
stant even under load condition.
Soft start feature
Safety and soft start because of suppressed starting shock.
Lighting up the lamps
CAUTION:
• Do not look in the light or see the source of light directly.
To turn on the lamp, pull the trigger. Release the trigger to
turn it off.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp. Be
careful not to scratch the lens of lamp, or it may lower the
illumination.
Workpiece to be cut
Wood
Mild steel
Stainless steel
Aluminum
Plastics
Number on adjusting dial
4-5
3-5
3-4
3-5
1-4