Filter
Top Products
14
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
After replacing brushes, plug in the tool and break in brushes
by running tool with no load for about 10 minutes. Then
check the tool while running and electric brake operation
when releasing the switch trigger. If electric brake is not
working well, ask your local Makita service center for repair.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding these
accessories, ask your local Makita service center.
• Steel & Carbide-tipped saw blades
• Rip fence (Guide rule)
• Hex wrench 6
1. Limit mark
1
001145
1. Brush holder cap
2. Screwdriver
1
2
001979
Combination General purpose blade for fast and smooth rip,
crosscuts and miters.
Crosscutting For smoother cross grain cuts. Slices cleanly
against grain.
Rip-cutting Fast cuts with the grain. Large teeth for better
chip clearance and minimal binding.