Filter
Top Products
Installing or removing driver bit or dirll bit
I
CAUTION
:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Hold the ring and turn the
sleeve
counter-
clockwise to open the chuck jaws.
Place
the bit in the chuck
as
far
as
it
will go.
Hold
the
ring firmly and turn the
sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn
the
sleeve
counterclockwise.
Storage
of
driver bit
When not using the driver bit, keep it in the storage cavity on the tool.
Switch action
Tool speed
is
increased by increasing pres-
sure on the trigger. To start the tool,
simply pull the trigger.
Rlelease
the trigger
to stop.
CAUTION
:
Before inserting
the
battery cartridge into the tool, always check to
see
that the trigger
switch actuates properly and returns to the
"OFF"
position when released.
Reversing switch action
This tool has
a
reversing switch to change
the direction -of rotation. Slide the revers-
ing switch to the right for clockwise rota-
tion or to the left for counterclockwise.
Reversing
CAUTION:
Always check the direction of rotation before operation.
*Use the reversing switch only when the tool comes to
a
complete stop. Changing the
direction
of
rotation before the tool stops may ruin the tool.
7