Filter
Top Products
0
When you charge a new battery cartridge or a battery cartridge which has not been used
for
a long period,
it
may
not
accept
a
full
charge. This
is
a
normal
condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging
it
almost completely a couple
of
times.
0
If
you wish
to
charge two battery cartridges, allow
15
minutes between chargings on the
fast charger.
Installing or removing drill
bit
or driver
bit
CAUTION
:
Always be sure that the
tool
is switched off and the battery cartridge is removed before
installing or removing the bit.
To
install the bit, place
it
in the chuck as
far as
it
will go. Tighten the chuck by hand.
Place the chuck key in each of the three
holes and tighten clockwise. Be sure
to
tighten all three chuck holes evenly.
To
remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
After use, return the chuck key
to
the
storage cavity on the
tool.
Holding
tool
H'old the
tool
as shown in the figure.
When drilling a large diameter hole, hold
the
tool
firmly with both hands.
fi
Tighty
/
Chuck
key
7