Filter
Top Products
Installing or removing driver bit
CAUTION
:
Always be sure that the tool
is
switched off and the battery cartridge
is
removed before
installing or removing the bit.
Slide the
sleeve
toward the motor and in-
sert the bit into the
sleeve
as
far
as
it
will
go. Then release the
sleeve
to secure the
bit.
NOTE
:
If the bit
is
not inserted deep enough into the
sleeve,
the
sleeve
will not return to
its
original position and the bit will not be secured. In this
case,
try re-inserting the bit
according to the instructions above.
To remove the bit, slide the
sleeve
toward the motor and pull the bit out firmly.
Holding
tool
Hold the tool
as
shown in the figure.
When drilling
a
large diameter hole, hold
the tool firmly with both hands.
CAUTION
:
Before inserting the battery cartridge into the tool, always check to
see
that the trigger
switch actuates properly and returns to the
"OFF"
position when released.
7