Filter
Top Products
8
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
• Always switch off the tool before insertion or removal of
the battery cartridge.
• To remove the battery cartridge, pull out the set plate on
the tool and grasp both sides of the cartridge while
withdrawing it from the tool.
• To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Be sure to close the set plate fully before
using the tool.
• Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Charging
For DC9700A
1. Plug the battery charger into the proper AC voltage
source.
2. Insert the battery cartridge so that plus and minus termi-
nals on the battery cartridge are on the same sides as
their respective markings on the battery charger.
3. The charging light will come on and charging will begin.
If the charging light goes out soon, remove the battery
cartridge from the charger and let it cool off for more
than one minute. Then re-insert it and try to charge it
once more.
4. If the charging light goes out within one minute even
after repeating this procedure a couple of times, the bat-
tery cartridge is dead. Replace it with a new one.
5. When the charging light goes out after about one hour,
you may remove the fully charged battery cartridge.
CAUTION:
• Your new battery cartridge is not charged. You will need
to charge it before use.
1. Set plate
2. Battery cartridge
1
2
001718
1. Charging light
1
001889