Makita 6228D Drill User Manual


 
10
To start the tool, simply pull the switch trigger. Tool speed is
increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
Electric brake
This tool is equipped with an electric brake. If the tool consis-
tently fails to quickly stop after switch trigger release, have
tool serviced at a Makita service center.
Reversing switch action
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A side
for clockwise rotation or from the B side for counterclockwise
rotation.
When the reversing switch lever is in the neutral position, the
switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before operation.
Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation before
the tool stops may damage the tool.
When not operating the tool, always set the reversing
switch lever to the neutral position.
Speed change
To change the speed, first switch off the tool and then slide
the speed change lever to the II side for high speed or I
side for low speed. Be sure that the speed change lever is
set to the correct position before operation. Use the right
speed for your job.
CAUTION:
Always set the speed change lever fully to the correct
position. If you operate the tool with the speed change
lever positioned halfway between the I side and II
side, the tool may be damaged.
Do not use the speed change lever while the tool is
running. The tool may be damaged.
1. Reversing switch lever
16
14
1
2
16
14
1
A
B
002088
1. Low speed
2. High speed
3. Speed change lever
1
2
3
002096