Filter
Top Products
7
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
• Always switch off the tool before insertion or removal of
the battery cartridge.
• To remove the battery cartridge, pull out the set plate on
the tool and grasp both sides of the cartridge while
withdrawing it from the tool.
• To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Be sure to close the set plate fully before
using the tool.
• Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Charging
For DC9710
• Plug the battery charger into your power source.
• Insert the battery cartridge so that the plus and minus
terminals on the battery cartridge are on the same sides
as their respective markings on the battery charger.
Insert the cartridge fully into the port so that it rests on
the charger port floor.
• When the battery cartridge is inserted, the charging light
color will flash in red color and charging will begin.
• When charging is completed, the charging light goes
out. The charging time is as follows:
Battery 9100: approx. 60 minutes.
• If you leave the battery cartridge in the charger after the
charging cycle is complete, the charger will switch into
its “trickle charge (maintenance charge)” mode.
• After charging, remove the battery cartridge from the
charger and unplug the charger from the power source.
NOTE:
• The battery charger is for charging Makita battery
cartridge. Never use it for other purposes or for other
manufacturer’s batteries.
1. Battery cartridge
2. Set plate
001752
1
2
1. Battery cartridge
2. Charging light
3. Battery charger
002988
2
1
3